(1) Select the tool stability, the stability of the tool depends on the quality of the interface is relatively thin between the blade and the handle. To maintain stability, the need for good track V-shaped insert and base structure, and preferably with a relatively long blade, the cutting tool performance for such a structure is critical
(2) the optimization process can affect not only the result of clamping, and may also influence the degree of optimization. The basic principle is to minimize tool overhang for rigidity and to ensure as close to the center line of the cutting edge.
(3) The method for cutting well, suitable and adequate supply of cooling fluid and the direction is often crucial. .
(4) cutting bar, the cutting diameter of the workpiece will continue to become smaller, is close to zero when it reaches the center. But not the lower spindle speed before the feed rate is reduced through a few millimeters to complete.
(5) feed rate, feed also means cutting during the stay by changing the feed to control chip formation. Feed rate should also be the right tool for the pressure setting tool to ensure a straight path, and decreased at the end to avoid forcibly cut off, while ensuring their safety in interrupted cutting.
Finally concluded, the feed, the combination of blade and shank and a good method to use when cutting off a critical factor.